Don’t use climbing spikes when pruning your tree
Is your tree care provider using spikes to climb while pruning your trees? Ouch!
Climbing spikes are sharpened steel spikes attached to the climber's leg by leather straps and padded supports. A tree worker should only use them to access trees being removed. When these spikes are used on living trees, it is traumatizing to the tree and creates unnecessary damage.
Each puncture from a climbing spike produces a certain amount of tree tissue death, though this varies from tree to tree. In most cases, isolated wounds will seal, but over time, groupings of spike holes can cause the entire area on the trunk to die back with no chance of recovery. This happens when a tree is repeatedly climbed for pruning while using spikes.
The likelihood of piercing the cambium (living tissue beneath the bark) is high, even with larger trees and thick bark. If soon after the work is performed with spikes there is sap oozing from the wounds, the tree is responding to spike damage. Repeated damage of this type is harmful to the tree.
So why would climbers use spikes if they are harmful to the tree? There are a few exceptional situations where using spikes is appropriate, such as:
— When the tree is being removed.
— When branches are more than throwline distance apart and there is no other means of climbing the tree (for example: when there are no branches lower than 50 feet), with no access for an aerial lift device or crane.
— If the tree is too close to power lines and cannot be accessed safely by other means.
— To reach an injured climber.
Professional tree care companies are aware of the dangers of spikes and use proper tree equipment such as ropes and climbing harnesses to climb (or aerial lift devices or cranes, if accessible). This, coupled with their training and experience, contributes to the future health of the tree.